Machine Operator/Forklift Operator

SEEK•Manitowoc, WI

44d•$13 - $15•Onsite

About The Position

Light Industrial Assignment to Hire Would you like to work for a company that places a high value on their employees and encourages them to learn and grow within the organization? Would you like to have excellent benefits such as a focused wellness program, paid tuition, company uniforms, referral bonus program, and community involvement opportunities? This is a 2 nd shift position but may train on 1 st shift before moving to 2 nd . 2 nd shift hours are 3:00pm – midnight. May have to work OT during the week after midnight. May have to work OT on Saturdays. Need to have forklift driving experience. Good attendance is a MUST. POSITION – Machine Operator/Forklift Operator. JOB LOCATION – Manitowoc, WI. STARTING DATE – Immediate. EMPLOYMENT TERM – Temp-to-hire. EMPLOYMENT TYPE – This is a full-time position. WORK HOURS (SHIFT) – 2nd shift, 3pm-12am. STARTING PAY – $13-$15/hour. REQUIRED EDUCATION – High School Diploma/GED. REQUIRED EXPERIENCE – Previous experience with machine operation and forklift driving.

Requirements

Previous experience with machine operation and forklift driving.
High School Diploma/GED
Good attendance is a MUST

Responsibilities

Starts-up and inspect all upcoiler, sheet cooler, shear motors, and equipment.
Operate equipment to bring metal through sheet cooler.
Operate equipment and shear to cutback metal to proper width.
Operate equipment to coil metal to proper ID.
Band and mark coil with F.O #, Coil #, and heat #.
Operate forklift to properly store coils in floor racks.
Complete shop paperwork as coils are being rolled.
Assist with all roll changes and coolant tank cleaning.
Assist with cleaning run-out table rollers and changing felt roller pads when necessary.
Inspect coils/metal for quality defects.
Notify supervisor if quality concerns are noted.
All other tasks as assigned by supervisor.
Willingness to cross train.
Advocate for continuous improvement projects.
Responsible for general and preventive maintenance of Rolling Mill equipment.
Follow and improve a program of lubrication for all Rolling Mill equipment, including frequency and specific lubricant to use.
Change Hot Mill table roller pads as needed.
Oil and sand Hot Mill table rollers as needed to eliminate roller marks.
Maintain proper levels of all hydraulic fluids and Hot Mill coolants.
Investigate, adjust and make minor repairs on any one of approximately 45 automatic lubrication systems.
Change and replace any of approximately 5 Fuller’s Earth filters.
Replace all remaining filter cartridges when necessary.
Maintain proper supply of lubricants and reorder when necessary.
Perform miscellaneous duties as assigned.
Comply with the Company’s quality management system requirements.
Willingness to cross train.
Advocate for continuous improvement projects.