Quality Control Inspector III/IV
About The Position
Work Schedule is four 10-hour days, preferably Monday through Thursday, 6:00am to 4:30pm. The Quality Control Inspector III or IV is responsible for routine (incoming, in-process, first article and final) QC inspection of raw materials, subassemblies and finished product. All receiving, in-process, first article and final inspections are performed in accordance with documented procedures and specifications. The QC Inspector III/IV shall ensure that inspection equipment is properly calibrated, handled and maintained. The QC Inspector IV documents inspection results and releases acceptable product for use. The QC Inspector III/IV identifies and segregates nonconforming product/processes for disposition by the Material Review Board. The Quality Control Inspector III/IV is responsible for performance of the following quality system functions in accordance with documented procedures: Inspection– Performing first article, receiving, in-process and final inspections in accordance with documented procedures. Assisting other personnel with inspection setups and questions. Process Control – Maintain product identification and traceability requirements throughout the inspection processes. Nonconformance Handling – Identification, documentation, evaluation, and segregation of nonconforming product pending review and disposition by the Material Review Board. Statistical Techniques – Employment of the appropriate statistical sampling techniques for inspection by attributes (ANSI/ASQ Z1.4).
Requirements
- Level III: At least 4 years of experience performing inspections in a regulated industry such as medical device, automotive, aerospace.
- Level IV: At least 6 years of experience performing inspections in a regulated industry such as medical device, automotive, aerospace.
- Adequate knowledge and understanding of the applicable quality system requirements (ISO 13485:2016, 21 CFR Part 820, etc.);
- Adequate knowledge and understanding of industry-standards for the sampling (ANSI/ASQ Z1.4) and inspection of product;
- Excellent organizational and communication skills.
- The ability to follow directions and interpret engineering and inspection specifications, including GD&T.
- Experience with a variety of inspection instruments such as calipers, micrometers, go/no-go gauges, optical comparators, air gages and CMM operation and programming.
- Experience with developing open inspection setups on surface plates using height gages, sine plates etc.
- Good written and verbal communication skills and familiar with problem solving skills.
- Requires a high school diploma or its equivalent.
Nice To Haves
- Experience with the inspection of high polished, tumbled, sand blasted and satin brushed surface finishes is a plus.
Responsibilities
- Performing first article, receiving, in-process and final inspections in accordance with documented procedures.
- Assisting other personnel with inspection setups and questions.
- Maintain product identification and traceability requirements throughout the inspection processes.
- Identification, documentation, evaluation, and segregation of nonconforming product pending review and disposition by the Material Review Board.
- Employment of the appropriate statistical sampling techniques for inspection by attributes (ANSI/ASQ Z1.4).
Stand Out From the Crowd
Upload your resume and get instant feedback on how well it matches this job.
What This Job Offers
Job Type
Full-time
Career Level
Mid Level
Education Level
High school or GED
